a new addition for your
existing Pop-Up
Our new Pop-Out is a low cost way to add something new to your existing Pop up display or dress up new panels with something a little different. This 3- dimensional add-on fits every Pop up frame we have ever handled, only takes a few minutes to put up, and will store in your pop up case for safe transport. Its location can be moved to left, right, or center position (also depends on your lights). The graphic can be produced on either premium quality Lambda Flex or cost efficient Inkjet. And we can provide a template to make designing the art a Snap. Here is a summary:
Assembly Instructions
The Pop-Out trade show graphic is packed with the Pop Up Panels, and should be the last item in the
case. Set up the display as usual, and then add the Pop-Out…
The Pop-Out is packed in a reusable cardboard wrap. Be sure to save the wrap for the
tear-down. The Pop-Out is designed to work on just about any brand of Pop-Up, and is
sized to pack in the same case as everything else…
Unfold the Pop-Out and set the hanger bracket braces… the braces will fold at a 90
degree angle, and the braces will “stick” to the Velcro Strips…
Orient the graphic face down with the bottom towards you and apply the Pop-Out. Start
with one of the bottom corners, and use the guide lines to insure the graphic is straight…
Although the Pop-Out can be installed from the front or back of the display, if you are
alone, the back is the best. Slide the slots on the brackets over the top of the Pop-Up
panels. Wrap the Hook/Loop Velcro strap around the closest back vertical tube on the
Pop-Up frame. Tension this strap to vertically straighten the header. Twist the strap so
that hook meets loop on the strap to insure a positive grip.
Looks Good! Have a great show!